Turn your analog sensors into smart alert devices with this helpful Z-Wave bridge. You only need one DC Signal Sensor to make it happen.
As long as your existing installation features interconnected mains powered detectors, it will take just a few minutes to add Z-Wave to them. Wire the DC Signal Sensor to the last detector in series and include it to your hub. The device can tell a smoke and CO alert apart so as long as your Z-Wave system fully supports both types of notifications, you’ll know exactly what’s going on.
NOTE: The device is NOT a life-safety security product. Check your local regulations before installing.
Maximize the value of your DC Contact Sensor by connecting the output relay to control a 120 V lights or siren for additional visual and audible alarms.
While the inputs of this smart device can detect smoke and CO signal, the output gives you remote and automated control of a high-voltage load of your choice. This can include an additional alarm siren that will go off when the detectors are triggered or color lights to help notify others of emergency with clear visual cues.