The Titan actuator can handle even the most stubborn valve, as long as it’s installed correctly.
You’ve been asking us for a reliable retrofit solution for ball valves for a while now. Most other devices out there are more difficult to install and simply not powerful enough to move the valve if requires a little more torque. The Titan was designed to move any ball valve up to 1.25″.
Watch the video to see just how strong the motor on the device is!
It takes less than a minute to mount the Titan actuator over your ball valve. You don’t need any tools either!
Follow the instructions in the installation video carefully to properly mount the device. Don’t skip ahead and complete each step to prevent malfunction. You’ll need 3″ clearance from the valve center to each side on the pipe, at least 1.25″ clearance between the valve handle and the pipe, and at least 1″ clearance between the pipe and the wall to mount the Titan successfully.
Always calibrate your valve actuator before adding it to your Z-Wave hub. The device will learn the start and stop point for your valve for reliable operation.